|
Electronic
ballast for use with 6000 W and 12000 W Metal
Halide Lamps |
- Available for daylight
lamps of all well-known manufacturers.
- Electronic detection
of the used lamp types 6000 W and
12000 W.
- Lamp power constant
controlled for steady light quality
independent of line voltage and of the age of the bulb used.
- Flicker free operation
by use of 75 Hz square wave current.
- Typical light ripple
max. 3% .
- Additional `low-noise`
modes (50 Hz / 60 Hz) to reduce
the noise that might occur in the lamp head.
- Optionally equipped with 300 Hz operation mode for use with digital 'high speed' cameras.
- Arc Control
to prevent unintended resonance arising
inside
bulbs of different designs.
- Dimming in range of
50 - 100% of nominal lamp power.
- With active line filter
(PFC) for minimized apparent power
and
reduced disturbances of Power supply network.
- Large range for input
voltage 180 - 250 V~.
- Additional input voltage range 90 - 125 V~ when used with
6000 W lamp
- Protection against
line overvoltage and overtemperature.
- Lamp outlet protected
against no-load conditions and
short circuit.
- Solid aluminum construction
witch outside heat sinks.
- Very silent due to
temperature regulated fans.
- Optionally equipped
with digital remote control (DMX512).
|
|
Technical
Data |
|
Lamp
Power |
6000
W / 12000 W |
Supply
Voltage |
90 - 125 V~ / 180 -
250 V~ 50 / 60 Hz 1,N,PE |
Line
Power |
6 kW: 6900 VA (max.)
12 kW: 13200 VA (max.) |
Power
Factor |
cos φ ≈0.98 |
Dimensions
(whd) |
263 498 506 mm |
Weight |
approx.
40 kg |
|