EB 2500 (230V)

Electronic ballast for use with 2500 W
Metal Halide Lamps

  • Available for daylight lamps of all well-known manufacturers.
  • Lamp power constant controlled for steady light quality independent of line voltage and of the age of the bulb used.
  • Flicker free operation by use of 75 Hz square wave current.
  • Typical light ripple max. 3% .
  • Additional `low-noise` modes (50Hz/60Hz) to reduce the noise that might occur in the lamp head.
  • Optionally equipped with 300 Hz operation mode for use with digital `high speed` cameras.
  • "Arc Control" to prevent unintended resonance arising inside bulbs of different designs.
  • Dimming in range of 50 - 100% of nominal lamp power.
  • With active line filter (PFC) for minimized apparent power
    and reduced disturbances of power supply network
  • Large range for input voltage 180 - 250 V~.
  • Protection against line overvoltage and overtemperature.
  • Lamp outlet protected against no-load conditions and short circuit.
  • Solid aluminum construction with outside heat sinks.
  • Very silent due to temperature regulated fan.
  • Optionally equipped with digital remote control (DMX 512).
Technical Data
Lamp Power 2500 W
Supply Voltage 180 - 250 V~ 50 / 60 Hz 1,N,PE
Line Power 2800 VA (max.)
Power Factor cos φ ≈ 0.98
Dimensions (w•h•d)
200 •156• 335 mm (H)
Weight approx. 8 kg